Vertex
| Line 19: | Line 19: | ||
<gallery width=150px height=150px> | <gallery width=150px height=150px> | ||
| − | file:vertex01-messung-transponder.jpg|measurement of transponder | + | file:vertex01-messung-transponder.jpg|Life view: measurement of transponder |
| − | file:vertex02-messung-baumfuss | + | file:vertex02-messung-baumfuss.jpg|Life view: tree bottom |
| − | file:vertex03-messung-baumkrone | + | file:vertex03-messung-baumkrone.jpg|Life view: tree crown |
| − | file:vertex04-anzeige-hoehenmessung | + | file:vertex04-anzeige-hoehenmessung.jpg|Display |
| − | file:vertex05-aufbau-transponder-plotmitte | + | file:vertex05-aufbau-transponder-plotmitte.jpg|Installation of transponder at a plot centre |
</gallery> | </gallery> | ||
Revision as of 21:59, 13 June 2012
 |
sorry: |
This section is still under construction! This article was last modified on 06/13/2012. If you have comments please use the Discussion page or contribute to the article! |
Contents |
General descripition
The Vertex clinometer is a device to measure distances based on ultrasonic sound and angles. It enables to directly measure tree height based on the trigonometric principle. For the measurement of distances a transponder is needed that is fixed at the tree and is an active component that submits a signal back to the Vertex. To determine the horizontal distance to the tree the transponder has to be fixed at a certain height (default 1,3 meter) that is defined in the settings menu.
The vertex clinometer allows to measure heights from variable distances to the target. The measurement results can be stored at the display to note them later down. When distances in a centre plot have to be measured, the 360° adapter can be placed at the centre point and the distances can directly be measured.
Life view: measurement of transponder
Life view: tree bottom
Life view: tree crown
Display
Installation of transponder at a plot centre
Applications
Related articles
