Measuring slope

Attention!:

This article must be enhanced to meet the AWF-Wiki quality standards! Please visit the Discussion Page of this article for details! Help to improve this article about Measuring slope if you can!

Forest mensuration lecture notes

[+] Definitions in forest inventory

[+] Functions and models in forest inventory

[+] Measurement devices

[+] Single tree variables

[+] Stand variables

  3D- Terrestrial laser scanning

  Forest Inventory Glossary

Slopes in forest inventory are more frequently measured in % than in degrees. Percent slope is determined by the ratio of rise over run; i.e. a 10% slope implies a vertical change of 10 units rise over a distance of 100 units run. For calculations, for example of trigonometric functions, this must be converted to degree or radian with the arctangent function.

Slope angle is measured either with electronic devices or, for example, with the Suunto Category:clinometer. Slope measurement takes place parallel to the terrain inclination. This is straightforward if it is an oblique plain. If the terrain is irregular around the point where the slope angle needs to be measured, then clear rules need to be defined. An example from the Swiss national forest inventory is given in Figure 1.

Figure 1 Uneven oblique plane as used in Field Manual 2nd Swiss NFI (Brändli et al 1994).