Haga
(→General description) |
(→Handling) |
||
| Line 12: | Line 12: | ||
==Handling== | ==Handling== | ||
The handling of the Haga is similar to the [[Blume Leiss]]. A button enables the actor to lock the needle where the measurement value can be read. | The handling of the Haga is similar to the [[Blume Leiss]]. A button enables the actor to lock the needle where the measurement value can be read. | ||
| − | + | ||
| − | + | <gallery widths=300px heights=300px> | |
| − | + | file: haga02_measurement-bottom.jpg|Figure 2: Live view measuring tree bottom | |
| − | + | file: haga03_measurement-top.jpg|Figure 3: Live view measuring tree crown | |
| + | </gallery> | ||
Remember the value and measure the crown. | Remember the value and measure the crown. | ||
Revision as of 15:24, 12 June 2012
 |
sorry: |
This section is still under construction! This article was last modified on 06/12/2012. If you have comments please use the Discussion page or contribute to the article! |
General description
Haga is a device to measure tree heights within distances of 15, 20, 25 and 30m to the tree by the trigonometric principle.The distance to three can optically be determined. Additionally there is a scale for slope measurements in % implemented. Therefore a levelling board is available.
Figure 1: Haga altimeter
Using a Haga altimeter
Handling
The handling of the Haga is similar to the Blume Leiss. A button enables the actor to lock the needle where the measurement value can be read.
Figure 2: Live view measuring tree bottom
Figure 3: Live view measuring tree crown
Remember the value and measure the crown. The difference between the measurements will be tree height – \[ {h_t} = {h_c} - {h_b} \].
The difference between the measurements will be tree height –
\[ {h_t} = {h_c} - {h_b} \].
[[Category:]]
