Measurement with the relascope
| Line 1: | Line 1: | ||
{{Content Tree|HEADER=Forest mensuration lecture notes|NAME=Forest mensuration}} | {{Content Tree|HEADER=Forest mensuration lecture notes|NAME=Forest mensuration}} | ||
| − | [[File:2.2.7-fig15.png| | + | [[File:2.2.7-fig15.png|right|thumb|285px|'''Figure 1''' Relascope units in the mirror relascope. The units are on a micro scale which adjusts automatically to slope; that is, the scale becomes more and more narrower with increasing deviation from the horizontal. By that construction principle it is guaranteed that one relascope unit corresponds to exactly the same absolute distance value at any height of the tree. (Kleinn 2007<ref name="kleinn2007">Kleinn, C. 2007. Lecture Notes for the Teaching Module Forest Inventory. Department of Forest Inventory and Remote Sensing. Faculty of Forest Science and Forest Ecology, Georg-August-Universität Göttingen. 164 S.</ref>).]] |
The relascope (the original German name is: Spiegelrelaskop) is a multifunctional hand-held measurement device developed by the Austrian forester [[Walter Bitterlich]]. It can be used for the so-called Bitterlich (or angle-count) sampling, for the measurement of [[:Category:Upper stem diameters|upper stem diameters]] but also for the measurement of [[slope angle]], [[tree height]] and other variables. A micro-scale in the device does automatically correct for slope angle. | The relascope (the original German name is: Spiegelrelaskop) is a multifunctional hand-held measurement device developed by the Austrian forester [[Walter Bitterlich]]. It can be used for the so-called Bitterlich (or angle-count) sampling, for the measurement of [[:Category:Upper stem diameters|upper stem diameters]] but also for the measurement of [[slope angle]], [[tree height]] and other variables. A micro-scale in the device does automatically correct for slope angle. | ||
Revision as of 18:54, 17 February 2011
The relascope (the original German name is: Spiegelrelaskop) is a multifunctional hand-held measurement device developed by the Austrian forester Walter Bitterlich. It can be used for the so-called Bitterlich (or angle-count) sampling, for the measurement of upper stem diameters but also for the measurement of slope angle, tree height and other variables. A micro-scale in the device does automatically correct for slope angle.
On that micro-scale there are measurement units (the so-called relascope units) which are being used for the measurement of upper diameters. Once it is determined, for a particular measurement, to how many centimeters one relascope unit corresponds, we can determine upper diameters by simply counting relascope units (Figure 1). The height, at which the measurement is taken, needs to be determined extra.
Usually one determines the relascope units by aiming at the known dbh. If for example a tree has a dbh of 60 cm and we count 6 relascope units when aiming with the relascope at dbh, then we know that each relascope units corresponds to 10 cm. If then for example at height 10 m we count 4.6 relascope units, we know that there the diameter is 46 cm.
Another possibility is to use the ratio 1:200. That means, if for example the horizontal distance to the tree is 10 m, one relascope unit would correspond to an object size of 5 cm. The relascope is complex in design but relatively simple to use. It is quite expensive. Visibility is a problem when light is bad. Of course, counting the relascope units and determine its fractions is difficult, above all for higher angles where the scale is very narrow.
References
- ↑ Kleinn, C. 2007. Lecture Notes for the Teaching Module Forest Inventory. Department of Forest Inventory and Remote Sensing. Faculty of Forest Science and Forest Ecology, Georg-August-Universität Göttingen. 164 S.
